1、 Requirements of Low price slurry electromagnetic flowmeter from China manufacturer on external environment

1）The Low price slurry electromagnetic flowmeter from China manufacturer shall not be installed in places where the temperature changes greatly or the equipment is exposed to high temperature radiation. If it must be installed, heat insulation and ventilation measures shall be taken.

2）It is better to install the Low price slurry electromagnetic flowmeter from China manufacturer indoors. If it must be installed outdoors, it should avoid rain pouring, ponding flooding and sun exposure. Moisture proof and sun protection measures must be taken.

3）Low price slurry electromagnetic flowmeter from China manufacturer shall not be installed in the environment containing corrosive gas, and ventilation measures shall be taken when installation is necessary.

4）In order to facilitate installation, maintenance and repair, sufficient installation space is required around the flowmeter.

5）The installation site of Low price slurry electromagnetic flowmeter from China manufacturer shall avoid strong magnetic field and strong vibration source. If the pipeline vibrates greatly, there shall be supports for fixing the pipeline on both sides of the flowmeter.

2、 Requirements of Low price slurry electromagnetic flowmeter from China manufacturer for straight pipe section

In order to improve the influence of eddy current and flow field distortion, there are certain requirements for the length of the front and rear straight pipe sections of the Low price slurry electromagnetic flowmeter from China manufacturer installation, otherwise the measurement accuracy will be affected (rectifier can also be installed, and the installation near the regulating valve and half open valve shall be avoided as far as possible).

3、 Requirements of Low price slurry electromagnetic flowmeter from China manufacturer for process pipe

The Low price slurry electromagnetic flowmeter from China manufacturer has certain requirements for the upstream and downstream process pipes at the installation point, otherwise the measurement accuracy will be affected.

1.）The inner diameter of upstream and downstream process pipes is the same as that of the sensor, and shall meet the following requirements: 0.98dn ≤ D ≤ 1.05dn (where DN: inner diameter of sensor, D: inner diameter of process pipe)

2）The process pipe and the sensor must be concentric, and the coaxial deviation shall not be greater than 0.05dn.

4、 Requirements for bypass pipe

In order to facilitate the maintenance of the Low price slurry electromagnetic flowmeter from China manufacturer, it is best to install a bypass pipe for the flow. In addition, for the heavily polluted fluid and the fluid that cannot be stopped when the flowmeter needs to be cleaned, a bypass pipe must be installed.